The Amber Electric Underfloor Heating Cable is ideal for small or large installations and awkward areas within a property where flexibility is required. The cable is able to provide a power output for either primary or secondary heat, depending on the cable spacing. Guaranteed with our SecureFloor 20 Year Warranty.
Compatible with most common floor finishes, Tile/Stone, Carpet, Vinyl and Timber. Can be installed directly on to the floor or used with the Amber Decoupling Membrane.
The Amber Electric Underfloor Heating Cable comes with full installation instructions, but don’t worry we offer full technical advise should you have any questions relating to the Heating Cable.
Warranty: SecureFloor 20 Year Warranty
Amber Electric Underfloor Heating Cable Technical Specification:
Operational voltage – 220 – 240V~
Construction – Round, twin conductor with 360° screening, one cold tail
Output – 10 W/m @230V~
Cable thickness – 4mm
Outer Sheath – PVC
Floor Coverings:
The underfloor heating system is compatible with most floor finishes, such as:
Tile/Stone – Fully encapsulate the Amber Cable with either a flexible smoothing compound or flexible tile adhesive, prior to the tile / floor finish being laid. Amber recommends the use of a plastic trowel when laying tile adhesive, to protect the underfloor heating cable from accidental damage.
Carpet – Fully encapsulate the Amber Cable with a flexible smoothing compound, to provide minimum of 10mm coverage above the top of the heating cable, prior to the carpet floor finish being laid. Avoid rubber or foam backed carpets. Please check with the carpet manufacturer to ensure the carpet is suitable for underfloor heating.
Timber – Fully encapsulate the Amber Cable with either 6-7mm of flexible smoothing compound layer, prior to the timber floor finish being laid. When installing natural wood floors it is recommended that soft wood floors should not exceed 20mm in thickness, hard wood floors should not exceed 30mm in thickness.
Vinyl – Fully encapsulate the Amber Cable with a 10mm bed of flexible smoothing compound, to provide minimum of 5mm coverage above the top of the heating element, prior to the vinyl floor finish being laid.
*Floor coverings should not exceed a thermal resistance of 0.15m²K/W
Full Technical Support is provided free of charge from project start to finish and we will assist with any queries you have to ensure your mind is put at ease.
Please ensure all Safety Guidelines are adhered to during, and after, installation of this product. Please be aware, we advise you choose a underfloor heating mat that covers 90% of your floor area. You CAN NOT cut the cables, therefore, it is best to order slightly less than you need.